Wall-mounted or placed on a table or countertop, this handsome display cabinet is the perfect way to share any collection while keeping it clean and protected at the same time. Featuring tempered glass doors and three shelves, the cabinet’s design calls for all straight cuts and straightforward construction techniques (simple cut-outs give the effect of
The beauty of this project lies in the simplicity. All you need are 3 pieces of wood of your choice (though we must admit natural hardwoods will look incredible), sanding block, clamps, wood glue and finishing product. The hardest step of the whole tutorial is measuring – as always, measure 9 times, cut once! You wouldn’t want to finish your project and then realize it doesn’t have enough space to fit your DVD player, would you?
Description: In this workshop, Ray explains the different types and uses of period layout tools. It amazes people to leans how few furniture "Plans" were used in 18th century work. Sketches were made and basic principles were applied to derive at their measurements for quick and efficient use of shop time. Learn what the term "Shop Math" means as Ray demonstrates how to figure out measurements without the use of a rule?
Working on one side at a time, glue and nail the side to the back. Apply glue and drive three 1-5/8-in. nails into each shelf, attach the other side and nail those shelves into place to secure them. Clamps are helpful to hold the unit together while you’re driving nails. Center the top piece, leaving a 2-in. overhang on both sides, and glue and nail it into place. Paint or stain the unit and then drill pilot holes into the top face of each side of the unit and screw in the hooks to hold your ironing board. Mount the shelf on drywall using screw-in wall anchors.
Begin by cutting off a 10-in. length of the board and setting it aside. Rip the remaining 38-in. board to 6 in. wide and cut five evenly spaced saw kerfs 5/8 in. deep along one face. Crosscut the slotted board into four 9-in. pieces and glue them into a block, being careful not to slop glue into the saw kerfs (you can clean them out with a knife before the glue dries). Saw a 15-degree angle on one end and screw the plywood piece under the angled end of the block.
Description: New to woodworking or looking to refresh your skills? What to see how someone else would do it? We have different Fundamentals classes where instructors teach you the skills to safely and properly use equipment, tools and jigs. In all classes you will learn about taking rough wood into a finished piece using the planer, jointer, mitersaw and tablesaw. In this class you will make a unique Shaker inspired step stool with a back/handle. Along with the tools listed above you will also use Porter Cable's box joint jig, router table, and a mortiser.